hey all i just bought a delta 1010, i have all 8 of my inputs going into my fast track ultra 8r, i want to then have all 8 analog outputs of the 8r go into my delta 1010. but only inputs 7 and 8 are reading in the delta's control panel, everything is hooked up right, it's just i am not sure if you can route all 8 outputs of the 8r as analog outputs. is there even a way?

i was hoping that with the USB cable not being hooked up, everything should be default to where u can then just use all 8 analog outs as that and not 1&2 for monitors and such.

if someone could respond a.s.a.p. that would be great!

thanks.

if i am not mistaken, you are not supposed to be able to send them all direct..
have you seen it done?
those outputs (to my knowledge) are just for extra headphone monitor output type deals, thats why two channels are showing up as a stereo mix..
i think.. not completely positive though..

I'm not the best with fast tracks but do you have anykind of mixer softwear with it?

because with my saffire pro 40, I can creat all my mix and rooting with the softwear of the interface and save it on the interface it self and the configuration remain the same as long as I don't plugg it to a computer

you know what i haven't even thought about that. I will read into more if i can do that with my software mixer. thanks!

your welcome, if you find a way to do it, post it here !